8.5.1.2. Installation
Fig. 8.55. Laying of a sealant and installation of stoppers
|
Arrange a sealant on an adhesive tape and establish the top stoppers, as shown in the figure 8.55.
And – 7 mm.
In – 40 mm.
Fig. 8.56. Installation of the lower clamps of glass
|
Establish the lower clamps of glass, as shown in the figure 8.56.
Fig. 8.57. The scheme of laying of soil on the contact surface of glass
|
By means of a brush or the pallet cover an edge and the contact surface of glass with primer of "G", as shown in the figure 8.57.
a – 7 mm.
b – 35 mm.
Fig. 8.58. Alignment of the glue which remained on a body
|
Knife level the glue layer which remained on a body be attentive, do not damage a paint and varnish covering of a body (fig. 8.58).
Clear a cut surface solvent.
NOTE
When cleaning try not to damage the painted body surface.
|
Temporarily establish glass into place.
Make sure that the surface of contact of glass absolutely equal and does not concern the lower brackets.
Apply combination tags on glass and a body.
Remove glass.
Fig. 8.59. The scheme of laying of soil on a contact surface of a body
|
Using the syringe, apply glue on all contact surfaces of glass along a ledge, as shown in the figure 8.59.
Sealant layer thickness in sections in the drawing:
a – 8 mm;
b – 12 mm.
Establish glass.
Arrange glass according to tags of combination and carefully press it along a rim.
Apply with the pallet glue on a glass edge.
Remove excess of glue with the pallet.
Strong press glass that it kept on glue.
After a while after material hardening, check tightness of connection.
Eliminate connection thinnesses with sealant for automobile glasses.
Apply glue and establish top and side moldings of a windshield.
Fig. 8.60. An installation site of an adhesive tape on the rain sensor
|
Remove an old adhesive tape from the sensor of a rain and establish new on the place designated by shading in the figure 8.60.
Install the rain sensor.
Establish a protective apron of a cowl and a drain trench.
Install other components as it should be, the return to removal.