8.5.1.1. Removal
Remove the following components:
– antisolar peaks and holders;
– the module of a plafond of illumination of salon and the regulator of provisions of the hatch on a roof;
– antisolar peaks and holders;
– top finishing of forward racks;
– cowl;
– screen wipers;
– forward protective apron;
– internal rear-view mirror.
Using a knife with a thin edge, remove a windshield sealant.
Fig. 8.51. Lines of a cut of a sealant of a windshield
|
NOTE
|
Fig. 8.52. Types of fastening of stoppers of a molding
|
NOTE
|
Fig. 8.53. Sites of installation of a cable for removal of a windshield
|
Stretch a string from salon and fix its ends on wooden whetstones (fig. 8.53).
Paste an adhesive tape on an external surface of a windshield not to scratch a surface.
At removal of glass try not to damage the painted surfaces and finishing.
Cut off a glue layer.
Remove glass.
Fig. 8.54. Removal of the remains of glue from a glass edge
|
By means of a scraper clear a glass edge of the remains of glue (fig. 8.54).
Wipe places where the glue remains were cleaned off by white spirit.
NOTE
Do not touch the fat-free surfaces.
|
Grease contact surfaces of the lower clamp with primer.
ATTENTION
Primer drying time not less than 3 min. You do not apply primer over glue. Open primer cannot be reused.
|