NOTE Procedures of adjustment of the left and right forward doors are identical.

Fig. 8.8. Centering and standard bolts

NOTE Because at adjustment of doors it is impossible to use centering bolts which door loops fasten, replace them with bolts with washers (standard bolts).

Fig. 8.9. Admissions of size of gaps of doorways

Examine forward doors and check that the size of gaps of doorways was in limits of the admissions designated in the figure 8.9.

NOTE The size of admissions is given in mm.

If the size of gaps differs from specified, adjust the provision of doors.

Fig. 8.10. Adjustment of longitudinally vertical position of a forward door

Having used the special tool 09812-00010, weaken fastening of door loops and adjust the provision of doors in vertical and longitudinal provisions (fig. 8.10).

Moment of an inhaling of adjusting bolts: 26 N · m.

Fig. 8.11. Adjustment of cross vertical position of a forward door

If it is necessary, adjust also cross vertical position of doors (fig. 8.11).

Moment of an inhaling of adjusting bolts: 26 N · m.