Remove from the case of the traction relay the starter case assembled with a winding of a starter and an anchor.

Fig. 7.41. Removal of the plug of a wire of the traction relay

Turn off a nut and disconnect the wire plug from a conclusion of the traction relay (fig. 7.41).

Fig. 7.42. Bolts of fastening of a cover of a starter from the drive

Turn off two bolts of fastening of a cover of a starter (fig. 7.42).

Uncover a starter from the drive.

Extend the starter case assembled with a winding of the stator and an anchor from the case of the traction relay.

Fig. 7.43. Extraction of a spring ring

Using tonkogubets, take a spring ring (fig. 7.43).

Fig. 7.44. Bolts of fastening of a cover of a starter from the switchboard

Turn off two coupling bolts of fastening of a cover of a starter from the switchboard (fig. 7.44).

Uncover the party of the switchboard.

Fig. 7.45. Extraction of a steel ball from an opening in the roller of the obgonny coupling

By means of a magnetic core take a steel ball from an opening in the roller of the obgonny coupling (fig. 7.45).

Fig. 7.46. Removal of the brush holder

By means of the screw-driver wring out a spring of a brush and disconnect a brush from the brush holder. Disconnect four brushes and remove the brush holder (fig. 7.46).

Make sure that positive (+) the wire is not closed on weight.

Take an anchor from the starter case.