2f3e5fd0

7.3.3.12. Assembly of the generator

Establish a generator cover from the drive on a rotor.
Establish a washer.
With plastic brisk install by the hammer the case of the vypryamitelny block. Fix the case by four nuts.
Inhaling moment: 4,5–5,4 N · m.

Fig. 7.29. Installation of insulators


Install four rubber insulators of the case of the vypryamitelny block (fig. 7.29).

ATTENTION
Install insulators carefully, trying not to damage them.

Install the plug and a sealing plate.
Install the vypryamitelny block, having fixed by its four screws.
Inhaling moment: 2,9 N · m.
Install tension relay regulator, having fixed by its four screws.
Inhaling moment: 2,0 N · m.

Fig. 7.30. Installation of the brush holder


Install the brush holder, having fixed by its two screws (fig. 7.30).
Inhaling moment: 2,0 N · m.
Establish a brush holder cover.
Establish a back cover and a plate of the rectifier.
Install the insulator of a conclusion, having fixed it by a nut.
Inhaling moment: 4,1 N · m.
Establish a pulley on a sock of a shaft of a rotor and tighten by hand a nut of fastening of a pulley.

Fig. 7.31. Installation of a pulley of a shaft of a rotor


Holding special 1-A adaptation a dynamometer key, tighten 1-B special adaptation (fig. 7.31).
Inhaling moment: 39 N · m.
Check that special 1-A adaptation was reliably fixed on a rotor.
Clamp special 1-C adaptation in a vice and install the generator on it.
For an inhaling of a nut of fastening of a pulley it is necessary to turn special adaptation (1-A) clockwise.
Inhaling moment: 111 N · m.
Remove the generator from special 1-C adaptation.
Unscrew special 1-B adaptation and remove special devices "1-A" and "1-B".
Make sure that the rotor rotates smoothly, without jamming.