Fig. 4.47. Installation of the lower insulator of a spring

Install the lower insulator of a spring as it is shown in the figure 4.47.

Install the compression course limiter on a rod.

Fig. 4.48. Compression of a spring преред installation

Using the special tool, squeeze a spring and establish it on a rack (fig. 4.48).

Fig. 4.49. Correct installation of a cup of the top support of a rack

Establish the top support of a rack as it is shown in the figure 4.49, and temporarily tighten a fastening nut.

Fig. 4.50. Orientation of a cup of the top support of a rack on tags

Orient a rack support cup as it is shown in the figure 4.50.

Fig. 4.51. Tightening of the central nut of the top support of a rack

Tighten the central nut of the top support of a rack, without removing the special tool squeezing a spring of the shock-absorber (fig. 4.51).

Inhaling moment: 49 N · m.

Remove the special tool.

Tighten 3 nuts of fastening of the top support of a rack.

Inhaling moment: 39 N · m.

PRIMECHANE After removal of the special tool, check correctness of installation of the top support again

Tighten two nuts of fastening from the lower party of a rack of the shock-absorber.

Inhaling moment: 255 N · m.

Fig. 4.52. Order of tightening of bolts of fastening of the holder of a brake hose and plait of wires of the sensor of frequency of rotation (ABS)

Tighten 2 bolts of fastening of the holder of a brake hose and a plait of wires of the sensor of frequency of rotation (ABS). Tighten them in the order specified in the figure 4.52.

Inhaling moment:

bolt of the holder of a brake hose: 19 N · m;

bolt of the holder of a plait of wires of the sensor of frequency of rotation (ABS): 5,5 N · m.

Install other components as it should be, the return to removal.

After installation check the angles of installation of back wheels.