Install the lower insulator of a spring on a rack.

Install the limiter of the course of compression of a spring on a rod.

Fig. 4.28. Compression of a spring of a rack with the help of the special tool

Using the special tool, squeeze a spring and establish a spring on a rack (fig. 4.28).

Fig. 4.29. Scheme of installation of the insulator of the shock-absorber and cup of a spring

Install the insulator of the shock-absorber and a cup of a spring. Combine a tag of "OUT" on the top cup of a spring with a tag on the insulator of the shock-absorber, as shown in the figure 4.29.

Fig. 4.30. Installation of a cup of a spring in the correct situation

Install the top cup of a spring by a tag to a back part of the car (fig. 4.30).

Fig. 4.31. Installation of the bearing and top support of a rack

Install the bearing and the top support of a rack, it is correct соорентировав them in relation to a back part of the car. (fig. 4.31).

NOTE Make sure that the bearing is installed in the top support of a rack.

Using the special tool, hold the top saddle of a spring and establish a new nut.

Inhaling moment: 49 N · m.

Establish other details as it should be, the return to removal.