3.4.4.1. Removal
Remove a forward wheel.
Using special adaptation 09930-00010, turn off a nut of a nave of a forward wheel.
Disconnect the forward sensor of speed.
Fig. 3.139. Bolts of fastening of a forward support
|
Having turned off 2 bolts of fastening, disconnect a forward support of a disk brake from a rotary fist (fig. 3.139).
Remove a forward disk.
Using special adaptation 09628-62011, disconnect the left steering draft.
Disconnect the lower lever of a forward suspension bracket No. 1.
Using the plastic hammer, separate the drive of a forward wheel assembled from a nave of a forward wheel.
ATTENTION
You watch to damaging a cover and a rotor of the sensor of speed of ABS
|
Fig. 3.140. Fastening of a rotary fist and nave of a forward wheel
|
Turn off 2 bolts, nuts and remove a rotary fist with a nave of a forward wheel (fig. 3.140).
Turn off the forelock and a nut.
Fig. 3.141. Removal of the lower spherical hinge of a forward suspension bracket
|
Using special adaptation 09628-62011, remove the lower sharovy hinge of a forward suspension bracket (fig. 3.141).
Fig. 3.142. Removal of a lock ring of the internal hinge of the left shaft of the drive
|
Using a stripper of lock rings, remove a lock ring of the internal hinge of the left shaft of the drive (fig. 3.142).
Fig. 3.143. Removal of a nave of a forward wheel
|
Using special adaptation 09520-00031, remove a nave of a forward wheel (fig. 3.143).
Fig. 3.144. Removal of an internal ring (outside of) a nave of a forward wheel
|
Using special adaptation 09950-00020 and a press, remove an internal ring (outside of) a nave of a forward wheel (fig. 3.144).
Using a wrench of Torx (T30), turn off 4 bolts and remove the protection cover of a disk brake.
Place an internal ring (outside) on the hug bearing of a forward wheel.
Fig. 3.145. Vypressovka of the hug bearing of a forward wheel in special adaptation
|
Using special adaptation 09527-17011 and a press, a vypressuyta the hug bearing of a forward wheel against the stop in special adaptation (fig. 3.145).
Fig. 3.146. Vypressovka of the hug bearing of a forward wheel
|
Using a wrench for horizontal installation of a rotary fist, establish it on a support, as shown in the figure 3.146.
ATTENTION
Make sure that the rotary fist is located horizontally.
|
Using special adaptation 09950-60010 and a press, a vypressuyta the hug bearing.