Fig. 3.107. Installation of electromagnetic valves of gear shifting

Install 5 electromagnetic valves of gear shifting and fix them by 5 bolts (fig. 3.107).

Inhaling moment:

A bolt: 6,6 N · m;

B bolt: 10,8 N · m.

Bolt length:

A bolt: 12 mm;

B bolt: 45 mm.

Establish a spring and the case of the backpressure valve.

Fig. 3.105. Extraction of the case of the backpressure valve and spring

Combine a groove of the manual valve with a pin on the lever (see fig. 3.105).

Establish 17 bolts of fastening.

Inhaling moment: 10,8 N · m.

Fig. 3.108. Order of tightening of bolts of fastening of the valvate block

ATTENTION For installation of the valve drown the valvate block, overcoming action of a spring of the piston of the hydroaccumulator and case of the backpressure valve. At first temporarily tighten the bolts noted by an asterisk in the figure 3.108 as they are adjusting.

Bolt length:

A bolt: 25 mm;

B bolt: 41 mm;

bolt of C: 45 mm.

Grease a new sealing ring of an oil filter with working liquid for the automatic transmission.

Establish a sealing ring of an oil filter.

Establish an oil filter and fix it by 3 bolts.

Inhaling moment: 10,8 N · m.

Grease a new sealing ring of the sensor of temperature of working liquid of the transmission with working liquid for the automatic transmission.

Install the sensor, a bolt and a lock plate.

Inhaling moment: 6,6 N · m.

Connect 5 sockets of electromagnetic valves of gear shifting.

Install 2 magnets in the oil pallet.

Grease bolts of fastening of the pallet with sealant.

Sealant: THREE BOND 2430 or analog.

Install the oil pallet, laying and tighten 18 bolts.

Inhaling moment: 7,8 N · m.

ATTENTION As bolts have to sit densely, apply on them sealant and tighten in 15 min. after use of sealant.

Fill in and check working liquid of the automatic transmission.