Fig. 2.370. Places of putting sealant on a cooling system cap

Remove the remains of old laying, wash out a cap of cooling systems, clear the easily evaporating solvent of a surface of a cap and the block and do not allow hit of oil on a cap prileganiye surface to the block of cylinders. Apply sealant on a cap, as shown in the figure 2.370.

Fig. 2.371. Stopper of discharge of cooling liquid

Screw a stopper of discharge of cooling liquid, having applied sealant on 2–3 rounds of its carving and having tightened its moment inhalings of 39 N · m. After achievement of the standard moment of an inhaling turn a stopper clockwise that its drainage tube was sent (fig. 2.371) down.

Wrap the union of an oil filter the moment of an inhaling of 30 N · m.

Establish an oil filter.

Fig. 2.372. Installation of new ring consolidation on the block of cylinders

Install new ring consolidation on the block of cylinders (fig. 2.372).