Fig. 2.364. Inserts of radical bearings

Establish inserts of radical bearings. Inserts of radical bearings differ on width, besides, the top inserts of radical bearings have the lubricant channel and lubricant openings (fig. 2.364).

Fig. 2.365. Number marking of a cover of the radical bearing

Combine ledges of the top inserts of bearings with bores (deepenings) of beds of the block of cylinders and insert inserts. Combine ledges of the lower inserts of bearings with bores (deepenings) in covers of radical bearings and establish them. Covers of radical bearings are numbered (fig. 2.365).

Fig. 2.366. Installation of the top persistent half rings in a bed of the block of the radical bearing No. 2

Establish the top persistent half rings in a bed of the block of the radical bearing No. 2 so that lubricant flutes were sent outside (fig. 2.366).

Lay a bent shaft in the block of cylinders.

Fig. 2.367. Correct orientation of persistent half rings to a bearing No. 2 cover

Establish covers of radical bearings and persistent half rings. Establish two persistent half rings on a bearing No. 2 cover, having oriented oil flutes outside (fig. 2.367).

Fig. 2.368. Installation of covers of radical bearings

Establish covers of radical bearings (fig. 2.368).

Fig. 2.350. Additive of covers of radical bearings

Apply a thin film of engine oil on carvings and under heads of bolts of fastening of covers of radical bearings. Temporarily tighten eight bolts of fastening of covers of radical bearings. Using the hammer with plastic brisk, seat covers of bearings for their dense prileganiye (see fig. 2.350).

Apply a thin film of engine oil on carvings and under heads of bolts of fastening of covers of radical bearings (with a 12-faced head).

Fig. 2.351. Order of tightening of bolts of covers of radical bearings

Establish and evenly tighten bolts of covers of radical bearings in several passes to the sequences, shown in the figure 2.351.

Fig. 2.352. The correct provision of a tag when tightening bolts of a head of the block of cylinders

Apply tags with paint on a forward part of bolts of a head of the block of cylinders. Tighten bolts of a head of the block of cylinders on 90 ° in the sequence stated above. Check that the tag put with paint costs on 90 ° from initial situation (see fig. 2.352).

Establish new sealing washers on bolts of fastening of covers of radical bearings (with a 6-faced head).

Fig. 2.353. Sequence of tightening of bolts of fastening of covers of radical bearings

Establish and evenly tighten bolts of covers of radical bearings in several passes to the sequences, shown in the figure 2.353.

Make sure that the bent shaft rotates smoothly. Using the dial indicator, measure an axial gap of a bent shaft when moving a bent shaft by the screw-driver.

Fig. 2.369. Places of putting sealant on the holder of a back epiploon

Apply sealant on the holder of a back epiploon, as shown in the figure 2.369.