Fig. 2.300. Combination of tags of gear wheels of the drive of the camshaft

Apply a layer of engine oil on the face persistent surfaces of the camshaft. Install the camshaft of final valves on 90 ° from situation when adjusting tags (1 point) on a head of the block of cylinders (fig. 2.300) are combined.

Fig. 2.301. Installation of an epiploon on the camshaft

Apply jellied lubricant on a new epiploon. Install an epiploon on the camshaft (fig. 2.301).

Fig. 2.294. Places of putting sealant: 1 – sealant

Remove old sealing material from a bearing cover. Apply sealant on a bearing No. 1 cover (see fig. 2.294).

Fig. 2.302. Marking of covers of bearings

Establish covers of bearings according to marking on their cases (fig. 2.302).

Fig. 2.303. Order of tightening of bolts of fastening of the right covers of bearings

Apply a thin film of engine oil on a carving and under heads of bolts of fastening of covers of bearings. Establish and evenly tighten ten bolts of fastening of covers of bearings in several passes the moment of an inhaling of 16 N · m in the sequence shown in the figure 2.303.