Establish VVT-i asterisk.

Fig. 2.145. Correct provision of an asterisk VVT-i: 1 – groove; 2 – pin

Hold an asterisk in such situation that the groove was in it a bit more to the left of an adjusting pin of the camshaft (at a look from a shaft) (fig. 2.145).

Install an asterisk on the camshaft. Slightly press an asterisk and turn it counterclockwise. Make sure that there is no visible gap between an asterisk and an end face of the camshaft.

NOTE Do not rotate an asterisk clockwise.

Fig. 2.146. Tightening of a bolt of fastening of an asterisk of VVT-i

Holding a shaft a key, tighten a fastening bolt the moment of an inhaling of 54 N · m (fig. 2.146).

Make sure that the VVT drive moves clockwise and is fixed by a lock pin in the correct situation. Temporarily wrap a fastening bolt. Holding a shaft a key, tighten a fastening bolt.