2f3e5fd0

2.2.8.12. Installation of the oil pallet

Fig. 2.163. Places of putting sealant on the surface of the pallet: 1 – sealant


Remove old sealant from the surfaces of connection of the pallet and a case, trying not to damage contact surfaces. Solvent clear contact surfaces. Apply sealant on the surface of the pallet, as shown in the figure 2.163.
The opening in a tube has to provide diameter of the squeezed-out sealant of 4 mm. Details have to be connected during the time specified in the instruction for use of sealant. Otherwise again remove sealant and lay new.
Upon termination of putting sealant the nozzle of a tube has to be removed and cleared of sealant traces, and the tube is densely closed.

Fig. 2.164. Bolts and nuts of fastening of the oil pallet


Install the pallet and tighten two nuts and twelve bolts of fastening of the oil pallet the moment of an inhaling of 9 N · m (fig. 2.164).
Wrap a drain stopper the moment of an inhaling of 25 N · m.