1.2.4.3. Multipurpose display
Fig. 1.77. Multipurpose display
|
By pressing the INFO button if the lock of ignition is switched on, on the index of hours or external temperature the following information (fig. 1.77) is displayed.
Every time when pressing the MODE or RESET button indication on the display switches between display of this information.
1. Instant fuel consumption.
2. Average fuel consumption.
3. Range of a trip.
4. Average speed of the car.
5. Time in way.
The values displayed on the multipurpose display show the general conditions of driving. Accuracy varies depending on a manner of driving and road conditions.
Press the INFO button once again, the display will come back to the index of hours and external temperature.
At inclusion of ignition on the display there will be the last mode which was used before shutdown of ignition.
If the power supply of the multipurpose display was switched-off, then the display will automatically be installed in the initial mode.
If to include dashboard illumination, brightness of the indicator of the display will decrease.
ATTENTION
You do not make adjustment of the display during the movement of the car. Before to make adjustment of the display, stop the car.
|
1. Instant fuel consumption
("L/100 km" (l / 100 km), "MPG" (miles/Gauls.) or "KM/L" (km/l)).
Instant fuel consumption is calculated and displayed on the display on the basis of distance and fuel consumption for 2 with at the working engine.
The value displayed on the display is updated each 2 pages.
Pay attention that exact value cannot be shown in the following cases.
– The car is stopped, and the engine works (on the display too big fuel consumption will be displayed).
– The car goes down a long slope, at the same time braking is used by the engine (on the display too low fuel consumption will be displayed).
Calculations are dumped at switching off of the lock of ignition.
2. Average fuel consumption
("AVG. L/100 km" (Wednesdays, l / 100 km), "AVG. MPG" (Wednesdays, miles/Gauls.) or "KM/L" (km/l))
Average fuel consumption is calculated and displayed on the display on the basis of the general passable way and the general fuel consumption at the working engine.
The value displayed on the display is updated each 10 pages.
For dumping of calculations press and hold pressed the MODE/RESET button during more than 1 page.
3. Range of a trip
("RANGE KM" (range, km) or "RANGE Ml" (range, miles))
The distance which the car can pass on the remained fuel is calculated and displayed on the display on the basis of amount of the remained fuel and the latest data on fuel consumption.
Indication of range of a trip on the display shows approximate distance which you can pass before achievement by the index of level of fuel of situation "E". It differs from really passable distance.
Digital value is updated every time when the fuel equivalent necessary for passing of 1 km (km) is spent.
During each filling of the car calculation is dumped.
Real range of a trip varies depending on a manner of driving and road conditions. At good fuel consumption range of a trip will be more. At bad fuel consumption range of a trip will be less.
If the control lamp of level of fuel lights up, refuel the car even if the display shows that the car can be conducted further.
4. Average speed of the car ("AVG. KM/h" (Wednesdays, km/h) or "AVG. MRN" (Wednesdays, miles/h))
Average speed of the car is calculated and displayed on the display on the basis of the general passable distance and the general time of driving at the working engine.
The value displayed on the display is updated each 10 pages.
For dumping of calculations press and hold pressed the MODE/RESET button during more than 1 page.
5. Time in the way ("à/T")
Time in way after start of the engine is displayed.
At start of the engine time in way is counted of 0:00. On the display indication of time of driving no more than 99:59 can be displayed (99 h, 59 min.). If time in way exceeds value 99:59, the counter will return to value 0:00.
For dumping of calculations press and hold pressed the MODE/RESET button during more than 1 page.