The mode of addition is used to keep already registered codes, at the same time registering new codes. This mode is used to add the new transmitter if necessary. If the number of the registered codes exceeds 4, then earlier registered codes respectively will be erased as it should be, since the first registered code.

The mode of rewriting is used to erase all previously registered codes and to register only new codes. This mode is used when replacing the transmitter or receiver of the control unit of a door of new.

The mode of the ban is used to erase all registered codes and cancels wireless control of door locks. Use this mode when the transmitter is lost.

The mode of confirmation serves in order that confirm how many codes were already registered before registration of an additional code.

For the correct registration of a code the following conditions have to be satisfied:

the key is not inserted into the ignition lock cylinder;

the door of the driver is OPEN (other doors are CLOSED);

the door of the driver is unblocked.

Execute the operations described below.

Insert and take out a key from the ignition lock cylinder twice during 5 pages.

Close and open the driver's door twice during 40 pages. Then insert a key into the cylinder of the lock of ignition and take out it.

Close and open the driver's door twice during 40 pages. Then insert a key into the cylinder of the lock of ignition and close a door.

Turn the ignition switch from the provision of "LOCK" in the provision of "ON" and back within about one second from 1 to 5 times, depending on the chosen mode. Then take out a key from the ignition lock cylinder.